I9300XXUFME3 – Android 4.2.2 Jelly Bean leaked firmware for the Galaxy S III

funny

Fm: http://www.sammobile.com/2013/05 ... r-the-galaxy-s-iii/



3 y, X' I; G5 E0 rNew enhancements in Android 4.2.2 update
- Android 4.2.2 – Build ID: JDQ39
- New S4 Lockscreen: Multiple Widgets, two Unlock effects (Ripple and Light), improved ripple effect than Android 4.1.2, ability to change clock size and set a personal message
: e3 \6 c0 q7 Y+ l/ C+ K. w8 O. H0 y- New Screen modes (From S4): Adapt Display and Professional Photo
- Daydream
- Driving mode
& V$ `0 f4 `: a- C* j- Actionable notifications
- New Additions in Notification Center
6 O, h- o8 b$ v% c/ C  D) F9 o- Completely revamped Settings UI (Tabbed interface – Exactly like the S4)
- Addition of Voice controls (Let’s you control various parts of the phone using voice commands – Galaxy S4 feature)
) ^3 W4 @/ V6 \/ J- Gallery modes have white background (When changing gallery modes to 3D the background changes to white)
- Full screen Samsung apps
- New S-Voice (from S4)
: \1 U' ^$ s: b: A( C( V# z- New smart switch widget
- Found more? Tell us about them in the comments below!
; o2 K- D8 u; h. d8 t
WARNINGS
- This firmware will increase your binary counter but the current binary and system status will remain official.
" A6 F* t) q/ c, R: ]- We have re-packaged this firmware from dump files.
- There is no modem in this firmware, so the Modem you will be using before flashing this firmware will remain the same.
- This is a pre-release firmware and not official from Samsung.
" P: w- \/ j7 ?8 q; y- We have fully tested this firmware and this firmware works perfectly as any other official firmware.

Firmware Details
& y* T& g( `' m& tAndroid Version: 4.2.2 – JDQ39 (Jelly Bean)
, |3 M$ D: V- mPDA: I9300XXUFME3
+ O  c$ o- s. J( V- G. B" y+ ~* qCSC: I9300OJKFME1
MODEM: N/A
Region: Middle East
1 e+ C6 |6 D. e8 S; x. @, iCarrier: Branded
Changelist: 611730
Build Date: 8 May 2013
" i- P! W  S3 g5 f. J! |Download: I9300XXUFME3_I9300OJKFME1_ILO.zip
9 M1 t" \. p, y$ m; `# n5 M
: n5 i( J! H& y" i5 F2 rFlashing Instructions
- Unzip the file
+ s$ \4 s3 C- p: i  F$ O2 i" [+ m+ f- Open Odin 3.04 (already included in the firmware package)
- Restart phone in download mode (Press and hold Home + Power + Volume down buttons)
- Connect phone and wait until you get a blue sign in Odin
- Add I9300XXUFME3_I9300OJKFME1_HOME.tar.md5 to PDA
- Make sure re-partition is NOT ticked
- Start flash, sit back and wait a few minutes.
- If you encounter any issues with the firmware (Any FC, Bootloop etc)
" Z) M7 K' {) V- Boot into recovery mode (Home+power+vol up)
! A  F4 I: z& Y. Q- Choose to wipe/factory reset. (THIS WILL ERASE ALL OF YOUR DATA INCLUDING YOUR INTERNAL SD CARD!)
. U( R3 i: U$ ^- N1 h- Then choose reboot and you should be good to go!
2 j1 X) C' O+ d2 e  m9 u/ f. g