I9300XXUFME3 – Android 4.2.2 Jelly Bean leaked firmware for the Galaxy S III

funny

Fm: http://www.sammobile.com/2013/05 ... r-the-galaxy-s-iii/

" G( S. W/ o/ O* D( N: ~4 o" `+ F8 A

New enhancements in Android 4.2.2 update
- Android 4.2.2 – Build ID: JDQ39
- New S4 Lockscreen: Multiple Widgets, two Unlock effects (Ripple and Light), improved ripple effect than Android 4.1.2, ability to change clock size and set a personal message
- New Screen modes (From S4): Adapt Display and Professional Photo
- Daydream
- Driving mode
- Actionable notifications
- New Additions in Notification Center
- Completely revamped Settings UI (Tabbed interface – Exactly like the S4)
- Addition of Voice controls (Let’s you control various parts of the phone using voice commands – Galaxy S4 feature)
* {. s$ P; l4 V# m9 g7 }- Gallery modes have white background (When changing gallery modes to 3D the background changes to white)
5 E% l$ m6 A$ W8 l; b# ^- Full screen Samsung apps
- New S-Voice (from S4)
- New smart switch widget
- Found more? Tell us about them in the comments below!

WARNINGS
- This firmware will increase your binary counter but the current binary and system status will remain official.
- We have re-packaged this firmware from dump files.
- There is no modem in this firmware, so the Modem you will be using before flashing this firmware will remain the same.
- This is a pre-release firmware and not official from Samsung.
- We have fully tested this firmware and this firmware works perfectly as any other official firmware.
! u! z8 l, k. U5 y( `' z
Firmware Details
Android Version: 4.2.2 – JDQ39 (Jelly Bean)
# U& \0 [7 v3 Y3 P! a3 ZPDA: I9300XXUFME3
CSC: I9300OJKFME1
MODEM: N/A
. t, ~7 o* ]( D, x  pRegion: Middle East
Carrier: Branded
Changelist: 611730
- V5 W8 O( p) SBuild Date: 8 May 2013
& l1 Q9 N! G, R+ k; k; a( uDownload: I9300XXUFME3_I9300OJKFME1_ILO.zip
% l+ ^- K8 k) c6 f; z- P# c
Flashing Instructions
% _3 R* E! A0 ^8 H, _. F( s* O- Unzip the file
1 Y; Q" ~1 l4 G8 H2 T+ [- Open Odin 3.04 (already included in the firmware package)
& [$ l% w. B) }* X% ~3 g; ~: D- Restart phone in download mode (Press and hold Home + Power + Volume down buttons)
- Connect phone and wait until you get a blue sign in Odin
2 U( r( o/ c) \; ]2 {6 r5 a- Add I9300XXUFME3_I9300OJKFME1_HOME.tar.md5 to PDA
- Make sure re-partition is NOT ticked
7 N) v& K% ]7 e- Start flash, sit back and wait a few minutes.
- If you encounter any issues with the firmware (Any FC, Bootloop etc)
- Boot into recovery mode (Home+power+vol up)
- Choose to wipe/factory reset. (THIS WILL ERASE ALL OF YOUR DATA INCLUDING YOUR INTERNAL SD CARD!)
- Then choose reboot and you should be good to go!