I9300XXUFME3 – Android 4.2.2 Jelly Bean leaked firmware for the Galaxy S III

funny

Fm: http://www.sammobile.com/2013/05 ... r-the-galaxy-s-iii/


9 j! k' z/ e# A9 X. K
New enhancements in Android 4.2.2 update
5 \: W' d! q* u$ r$ I, U- Android 4.2.2 – Build ID: JDQ39
/ T  C' Q0 k0 M4 {6 j- New S4 Lockscreen: Multiple Widgets, two Unlock effects (Ripple and Light), improved ripple effect than Android 4.1.2, ability to change clock size and set a personal message
1 w3 O' ^% B1 f! p- New Screen modes (From S4): Adapt Display and Professional Photo
$ h/ S- s% L, N8 n7 Y  p( ?" @2 X- Daydream
- Driving mode
6 E# P3 G, o# k/ X! P3 d2 E) m/ w- Actionable notifications
- New Additions in Notification Center
- Completely revamped Settings UI (Tabbed interface – Exactly like the S4)
: [6 u8 y& i' A7 B- Addition of Voice controls (Let’s you control various parts of the phone using voice commands – Galaxy S4 feature)
- Gallery modes have white background (When changing gallery modes to 3D the background changes to white)
$ a) _4 T# v* _: S1 z9 o- Full screen Samsung apps
* i2 t1 _8 O/ A  G- New S-Voice (from S4)
& }( l6 C) _) p- New smart switch widget
- Found more? Tell us about them in the comments below!

WARNINGS
- This firmware will increase your binary counter but the current binary and system status will remain official.
- We have re-packaged this firmware from dump files.
# o; ?" u  U% M1 w0 {5 T- There is no modem in this firmware, so the Modem you will be using before flashing this firmware will remain the same.
- This is a pre-release firmware and not official from Samsung.
- We have fully tested this firmware and this firmware works perfectly as any other official firmware.
, r  a9 F# ?) {; h
2 Z! Z0 Y" c- c9 f+ N/ ~) s5 H' n0 }Firmware Details
( G' a) q$ K( Y' {  aAndroid Version: 4.2.2 – JDQ39 (Jelly Bean)
PDA: I9300XXUFME3
CSC: I9300OJKFME1
MODEM: N/A
Region: Middle East
Carrier: Branded
Changelist: 611730
Build Date: 8 May 2013
Download: I9300XXUFME3_I9300OJKFME1_ILO.zip
+ C( _  g- B( p# k# q, [/ @
* `. u  t( A8 MFlashing Instructions
- Unzip the file
* \8 {3 L: H% i4 \' x- Open Odin 3.04 (already included in the firmware package)
9 s' {/ s- L  d( _" y9 ?- Restart phone in download mode (Press and hold Home + Power + Volume down buttons)
- Connect phone and wait until you get a blue sign in Odin
. B+ t% K3 i- v; G& E- l4 J, ^0 P- Add I9300XXUFME3_I9300OJKFME1_HOME.tar.md5 to PDA
- Make sure re-partition is NOT ticked
5 S; I) H+ w" ], G5 E- Start flash, sit back and wait a few minutes.
$ Y$ S" j, |: q+ x9 o5 ?- If you encounter any issues with the firmware (Any FC, Bootloop etc)
- Boot into recovery mode (Home+power+vol up)
- Choose to wipe/factory reset. (THIS WILL ERASE ALL OF YOUR DATA INCLUDING YOUR INTERNAL SD CARD!)
- Then choose reboot and you should be good to go!